30 thoughts on “Flite Test | FT Mini Speedster – BUILD (Mighty Minis)

  • August 31, 2017 at 2:33 am
    Permalink

    i have my cg 0.5 cm fowards is that alright
    pls i gonna testflite over about a week

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I m from northern part of India and we don't have this kind of foam. The foam available here are the ones that u have but without the paper part and I don't think they are much flexible. Suggest something guys!

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I was thinking about trying out this model. would an 1806 motor, 3s 2200 battery, 6045 prop, 2 9gram servos and 20a esc work?

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I am just curious is A in power pod on pdf plans pointed to wrong side? This a small plane shouldn't it have a bit of down and right trust angle included?

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I'm just wondering if you need to put the rudder on because I want to get a three channel radio but that wouldn't work with a rudder. This will be my first proper plane and I'm just wondering if you sell these to England

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    Scratch built this guy, running the A pack 1806 with a 800mah 3S and 6030 prop, it is a very subtle and gentle flyer! The wheels I bought were a little too big, it'd be cool if you guys could suggest which wheels fit which aircraft best, taking into account things like the wheel pants, etc…

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I'm getting the speed kit in the mail. I'm only 13 so my brother will help me.

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    To get round wheels from foam cut them slightly over size but have your round circles drawn. Stick a BBQ skewer thru them cut short. A drop of glue on the skewer and the wheel to make the wheel turn with the skewer, them "simply" place the skewer end into a drill and "simply" hold a sanding block to the wheels while spinning them in the drill to take them down to your drawn circle. Works great and gets them more round than trying to cut circles.

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    Once again, great stuff, Josh! Just a little tip/trick that I use that I haven't seen you utilize….when making your guide or piece to check for perpendicular, if you come up just three eights or so on both sides from the 90 degree corner and "simply" cut the very corner off of the guide it still works just fine but eliminates the potential for gluing the guide to the piece your holing it to as the glue dries.

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    you can turn this into a warbird by putting on a cockpit and painting it so it matches the british mk1 boomerang

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    This is cool! I bought this and power pack A… That didn't come with a receiver. Was that something I was supposed to buy seperste

    Reply
  • August 31, 2017 at 2:33 am
    Permalink

    I want to try this one. Hard to find material in Sweden. Did find boards of EPP plastic (6mm thick). They come in two densities: 20 gram/dm3 and 30 gram/dm3. Which one do you recommend for this plane?

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *